Installation Conditions - SMA SUNNY TRIPOWER 60 Instructions D'installation

SMA Solar Technology AG

5.4 Installation Conditions

Parameter
Operating temperature range
Storage temperature
Relative humidity
Pollution degree
Environmental category IEC62109-1
Environmental class in accordance with IEC 60721-3-4
Cooling concept
Air quality - general
Air quality - coastal, heavy industrial and agricultural zones Must be measured and classified in accordance with ISA
Vibration
Enclosure protection class
UL 50E enclosure type
Maximum operating altitude above mean sea level
Installation
* Installations at heights >2,000 are possible on request. Contact SMA Solar Technology AG.
Table 5.6 Installation conditions
Installation Guide
Specification
-25°C to 60°C (possible power reduction above 45°C)
(-13°F to 140°F) (possible power reduction above 113°F)
-40°C to 60°C
95% (non-condensing)
PD2
Outdoor, wet (see Section 2, page 21)
4K4H/4Z4/4B2/4S3/4M2/4C2
Forced cooling
ISA S71.04-1985
Level G3 (at 75% RH)
S71.04-1985: G3 (at 75% RH)
< 1 G
IP65
NEMA 3R
2,000 m (6,500 ft) above sea level (derating may occur at
an altitude over 1,000 m).*
Avoid constant stream of water.
Avoid direct solar irradiation.
Ensure adequate air flow.
Mount on non-flammable surface.
Mount upright on vertical surface.
Prevent dust and ammonia gases.
5 Technical Data
STP60-10-IA-xx-10 49