Initial Setup Via Lcs Tool; Turn Pv Load Switch On; Start-Up - SMA MLX Série Guide D'installation

Initial Setup and Start
Illustration 3.1 Overview of Display Buttons and Functionality
Key Function
Adjust contrast level of display. Use
F1 arrow up/down button while holding
down the F1 button.
F2
F3 Not in use
F4
Home Return to main screen
Not in use
OK
Arrow Up A step up
Arrow Down A step down
Arrow Right Toggles screen right
Arrow Left Toggles screen left
Back Return to main screen
On - Green LED
Alarm - Red LED
Table 3.2 Overview of Display Buttons and Functionality
The screen structure is divided into 3 sections:
1. Main screen. Current and daily production. This
section contains:
•
Actual power output (kW)
•
Energy counter current day (kWh)
•
Total energy counter (kWh)
•
Current date
•
Current time
•
Operation mode (#)
2.
Inverter information. This section contains:
•
Inverter type
•
Inverter name
•
Serial no.
3.

3.2.1 Initial Setup via LCS Tool

The LCS Tool makes it possible to chose from a list of
predefined settings for different grids. All grid-specific
limits must be configured using the LCS Tool.
After installation, check all cables and close the inverter.
Turn on AC power.
WARNING
Correct selection of grid code is essential to comply with
local and national standards.

3.2.2 Turn PV Load Switch On

Illustration 3.2 PV Load Switch
Turn PV load switch on, either via inverter or string
combiner.

3.2.3 Start-up

The inverter starts automatically if sufficient solar
irradiation is available. The start-up takes a few minutes.
During this period, the inverter performs a self-test
procedure.
NOTICE
The inverter is protected against reversed polarity. The
inverter does not generate power until any reversed
polarity is corrected.
L00410644-01_2q / Rev. date: 2014-06-02
•
IP address
•
Inverter Manager MAC address
•
Inverter software version
Actual values. This section contains:
•
PV voltage and current
•
Phase-to-phase voltages
•
Phase currents
•
Grid frequency
3 3
21