Technical Data - Meec tools 012176 Mode D'emploi

EN
• To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
• Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
– Only use the tool in accordance with
these instructions.
– Check that the tool is in good
condition.
– Use accessories in good condition,
and which are suitable for the
purpose.
– Keep a firm grip on the handles/
grips.
– Maintain and lubricate the tool in
accordance with these instructions.
Symbols
The following symbols can be of importance
for how you should use your power tool. Make
sure you understand the symbols and their
significance.
Read the instructions.
Wear eye and ear protection.
Wear a dust filter mask.
Wear safety gloves.
66
Warning: Do not look
directly into the laser beam!
The machine has a laser.
This type of laser device
does not normally involve
any risk of eye damage, but
looking directly into the laser
beam can cause temporary
blindness.
Laser Warning Label: Max
output < 5 mW, wavelength:
630-660 nm, complies with
21CFR 1040.10 and 1040.11
Class IIIa laser product.
Laser Aperture Label:
AVOID EXPOSURE: Laser
radiation is emitted from this
aperture.
Approved in accordance with
the relevant EU directives.
Recycle as electrical waste.

TECHNICAL DATA

Battery voltage
Blade
Blade capacity
Speed
Sound pressure level, LpA 81.2 dB(A), K=3 dB
Sound power level, LwA
Vibration level
Weight
Always wear ear protection!
The declared vibration value and noise, which
have been measured by a standardised test
method, can be used to compare different
18 V DC
Ø 185 mm
185 x 16 mm
0 – 5000 rpm
101.2 dB(A), K=3 dB
4.128 m/s², K=1.5 m/s²
11 kg