Meec tools 012176 Mode D'emploi page 74

EN
completely stopped before lifting up the
saw head.
• Check the spindle screw at regular
intervals and tighten, if necessary.
Jammed material
Follow the instructions below before removing
jammed material.
– Release the power switch, wait until
all moving parts have stopped and
then remove the battery.
Carriage
IMPORTANT:
Move the carriage to the back position after
sawing to reduce the risk of personal injury.
FIG. 26
• To saw small pieces move the saw head as
far back as possible and tighten the lock
knob for the carriage (1).
• When sawing wide workpieces, up to 20
cm, the lock knob for the carried (1) must
be released so that the saw head can
move freely.
Mitre sawing
FIG. 27
1. Release the saw table by turning the adjuster
handle for the mitre angle (1) anticlockwise.
2. Lift up the lock arm for fixed stop (2).
3. Turn the saw table to the left or right with
the adjuster handle for the mitre angle.
4. When the saw table is at the right angle
according to the mitre angle scale (3),
release the lock arm for fixed stop and
tighten the adjuster handle for the mitre
angle. The saw table is now locked at the
required angle. There are fixed stops for 0°,
15°, 22.5°, 31.6° and 45°. IMPORTANT:
74
Check and tighten the adjuster handle for
the mitre angle before sawing.
Bevel sawing
FIG. 28
1. Release the lock lever for the bevel angle
(1) by turning it clockwise.
2. Turn the saw head to the required angle
on the bevel angle scale (2).
3. The blade can be set to an angle of 90°
(0° on the scale) to 45° left. Tighten the
lock lever for the bevel angle (1) to lock
the saw head at the set angle. There are
fixed stops for 0° and 45°.
Combination sawing
The mitre angle and bevel angle are used
together for combination sawing.
FIG. 29
• Release the lock lever for the bevel angle
(1) and move the saw head to the
required bevel angle. Tighten the lock
lever for the bevel angle (1).
• Release the adjuster handle for the mitre
angle (2). Lift up the lock arm for fixed
stop (3) and turn the saw table to the
required angle. Release the lock arm for
fixed stop (3) and tighten the adjuster
handle for the mitre angle (2).
Sawing wide workpieces
Follow the instructions below when sawing
workpiece up to 20 cm to avoid the risk of
personal injury and/or material damage.
IMPORTANT:
Secure the workpiece with a clamp, clips or
vice.
• Allow the blade to reach maximum speed
before it makes contact with the