Installing Fluorescence Filter - Optika Italy IM Serie Manuel D'instructions

• IM-3LD4 / IM-3LD4D
F I LT E R EXCITATION
NAME FILTER
M-1233 325-375 nm
M-1232 390-420 nm
M-1230 455-495 nm
M-1231 510-550 nm
M-1238 582-603 nm
M-1234 590-650 nm
M-1235 595-645 nm
M-1236 623-678 nm
M-1237 720-760 nm
14.4 Installing fluorescence filter
Only IM-3LD4 / IM-3LD4D
• This procedure can be needed when installing new
fluorescence cubes or when replacing an existing
cube with a different one.
1. Disconnect the power supply plug from the microscope.
2. Unscrew the filter selector lever.
3. Open the side cover of the illuminator, by unscrewing
the side screws ①. (Fig. 69)
• The cubes are mounted on the opposite side of the cov-
er: opening the left cover acts on the right side of the
slider and vice versa.
4. Remove the filter slider from the microscope and put it
on a table.
5. Using the screws provided with the fluorescence cube,
fix the new cube on the slider. (Fig. 70)
D I C H R O I C BARRIER
MIRROR FILTER
415 nm 435LP nm
440 nm 450LP nm
500 nm 510LP nm
570 nm 575LP nm
610 nm 615-645 nm
660 nm 665LP nm
655 nm 665-715 nm
685 nm 690-750 nm
770 nm 780LP nm
• DAPI
• Hoechst
• Coumarin
• Pacific Blue
• FITC
• GFP
• Rhodamine
• TRITC
• Propidium Iodide
• Red#2 FISH
• Cy5
• Cy5
• AlexaFluor 647
• Draq5
• Cy5.5
• Li_Cor IR dye 800
①
Page 41
APPLICATIONS
①
F ig. 69 F ig. 69
F ig. 70 F ig. 70