Connecting The Power Supply - Optika Italy IM Serie Manuel D'instructions

6. Plug the monitor power supply in the connector "F" on
the monitor. (Fig. 17)
7. Plug the other side of the HDMI cable in the connector
"G" on the monitor. (Fig. 17)
8. Plug the USB3.0 cable in the back side of the camera.
(Fig. 18)

7.10 Connecting the power supply

1. Turn the main switch to "O" (OFF) before connecting
the power supply.
2. Insert the jack of the power supply into the power sock-
et of the microscope. (Fig.19)
3. Plug the power supply into the mains socket. Check for
a safe connection.
• Please use the provided power supply. If lost or
damaged, please refer to qualified service.
• Connect the power supply to a grounded (earthed)
wall outlet only.
Page 21
F ig. 17 F ig. 17
F ig. 18 F ig. 18
F ig. 19 F ig. 19