System Assembling; Installing Adapter Ring; Installing The Ringlight; Connecting The Power Supply - Optika Italy ACCESSOIRES Serie Manuel D'utilisation

7.3

System assembling

7.3.1 Installing adapter ring

1. Screw the adapter ring at the end of the
microscope body. (Fig. 1)
• The adapter ring has a groove ① for the
connection of the ringlight illuminator.
• In case of installation on SZP series the
adapter ring is not needed. The SZP objective
has a groove for the adaptation of the ringlight
illuminator.

7.3.2 Installing the ringlight

1. Open the fixing knobs ② on the ringlight and fit
the illuminator on the adapter ring.
2. Screw the fixing knobs until the tips of the knobs
enter into the groove of the adapter ring. (Fig. 2)
• Only for CL-18: before installing the ringlight
it is mandatory to install the analyzer (see
chapter 7.3.4).

7.3.3 Connecting the power supply

CL-16.1
1. Plug the power cord on the back of the control
box. (Fig. 3).
CL-18
1. Plug the power supply on the side of the ringlight
illuminator. (Fig. 4).
①
②
②
Page 6
Fig. 1
②
Fig. 2
Fig. 3
Fig. 4