2. DIRECTIONS FOR USE
NOTE:.For.a.single.feeding.the.feed.interval.set-
ting.should.be.programmed.to.NONE.(Figure 2-13)..
When.you.have.finished.setting.rate.and.dose.check.
the.display.to.see.if.it.reads.FEED.INTERVAL..If.
it.does,.press.the.FEED
INT.key,.then.press.the.
Figure 2-13 Clear
CLEAR.key..Display.will.read.NONE.
Feed Interval
Step 6
Connect.barbed.adapter.to.the.patient's.enteral.feeding.tube.
Step 7
Press.the.RUN/PAUSE.key..Pump.will.begin.running..
Display.will.show.programmed.rate.and.the.arcs.
around.the.run.symbol.will.rotate.(Figure 2-14).
While.pump.is.running,.the.following.may.be.viewed.
Figure 2-14 Pump
by.pressing.the.appropriate.key:.Rate,.Dose,.and.
is Running
Feed.Interval.
To.view.the.amount.delivered.in.the.current.feeding,.
press.the VOL/TOTAL.key.(Figure 2-15)..This.coun-
ter.will.reset.itself.when.the.previously.programmed.
dose.has.been.completed.and.a.new.feeding.is.start-
ed,.or.if.a.feeding.is.interrupted.and.Rate,.Dose.or.
Figure 2-15 Amount
Feed.Interval.is.changed.
Currently Delivered
To.view.the.amount.delivered.over.the.course.of.sev-
eral.feedings.press.the.VOL/TOTAL.key.a.second.
time..Display.will.read.TOTL.then.the.amount..This.
counter.never.resets.itself..It.can.only.be.reset.by.the.
user.(Figure 2-16).
Figure 2-16 Total
Amount Delivered
While.pump.is.running,.the.settings.cannot.be.
changed.and.the.Prime.feature.is.disabled..
If.you.want.to.stop.pump.at.any.time,.press.the.RUN/PAUSE.key..Display.will.show.
rate,.and.pump.will.be.in.pause.mode..Or,.turn.pump.off.by.pressing.the.ON/OFF.key.
11
© Copyright 2013 Moog, Inc.