Shutting Down And Cleaning - WAGNER W550 Mode D'emploi

GB

Shutting down and cleaning

1. Pull out the mains plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2. Disassemble the gun.
3. Unscrew the container. Empty the rest of the coating material back into the can.
4. Pre-clean the container and feed tube using a brush. Clean the ventilating bore (Fig.1C).
5. Fill the container with solvent or water. Screw on the container.
Use only solvent with a flash point of over 21°C.
6. Reassemble the gun.
7. Plug in the mains plug, switch on the unit and spray solvent or water into a container
or onto a cloth.
8. Repeat the above procedure until clear solvent or water comes out of the nozzle.
9. Switch off the unit and pull out the mains plug.
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
10. Pull the ventilating hose (Fig.1A, pos. 15) at the top from the gun body. Screw off the
valve cover (16). Remove the diaphragm (17). Clean all the parts carefully.
11. Unscrew the union nut, then carefully pull off the air cap, air tube and paint tube.
Unclip the needle from the needle holder (Fig.2, C). Depending on the paint type, use
solvent or water and a brush to clean all parts of the extension.
12. Wipe the outside of the spray gun and container with a cloth impregnated with solvent
or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig.1A, 17). Place the diaphragm
with the pin facing upwards on the bottom section of the valve. Also see the marking
on the gun body. Place on the valve cover and screw it closed. Place the ventilating
hose on the valve cover and on the nipple at the gun body. Slide the nozzle seal (Item
4) with the groove (slot) facing forwards into the nozzle (Fig.1B). Insert all the parts
of the extension into each other and keep in the packaging (Fig.1,pos. 3, 5, 6, 9).
Place the container seal from below on the ascending tube and slide it over the collar,
while turning the container seal slightly. Insert the ascending tube with container seal
in the gun body.
Pos. Designation
3 Needle, front section
4 Nozzle seal
5/6 Paint/air pipe
Australia (AUS) version order no. in brackets
8 Union nut
9 Air cap
12 Container seal
13 Feed tube
8
Spare Parts List (Fig. 1+6)
Detail / Radiator spray attachment
Order No.
0417 919
0414 353
0417 920
AUS (0417 926)
0417 319
0417 363
0417 358
0417 357