Interruption Of Work; Shutting Down And Cleaning - WAGNER Perfect Spray 800 Mode D'emploi

GB
When spraying horizontal surfaces, turn suction tube forward.
When spraying objects overhead, turn suction tube back.
Adjusting the material quantity
To prevent paint runs on the object, first adjust the paint quantity by spraying onto a piece
of card or paper from the same spraying distance.
First turn the adjustment knob (Fig. a, Item 7) fully to the left (-) and then slowly increase
the material quantity to the desired amount by turning it to the right (+). For further
information on setting the spray pattern and the correct spraying technique refer
to the instructions of the basic device.
The units may only be used with a functional valve. If paints rises in the
CAUTION!

ventilating hose (Fig. 1 A, item 12) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and
replace the diaphragm if necessary.
Do not lay the spray gun.

Assembly
The unit may only be operated with an integer diaphragm (Fig. 1 A, 14). Place the diaphragm
with the pin facing upwards on the bottom section of the valve. Also see the marking
on the gun body. Place on the valve cover and screw it closed. Place the ventilating hose
on the valve cover and on the nipple at the gun body.
Slide the nozzle seal (Item 3) with the groove (slot) facing forwards into the nozzle
(Fig. 1 B). Put the nozzle onto the gun body and find the correct position by turning it. Put
the air cap onto the nozzle and tighten it using the union nut.
Place the container seal from below on the suction tube and slide it over the collar, while
turning the container seal slightly. Insert the suction tube with container seal in the gun
body.

Interruption of Work

i
When processing 2-component varnishes, clean the device immediately.

Shutting down and cleaning

Please also refer to the instructions of the basic device.
1) Switch the unit off. Vent the container in case of longer breaks and after the work has
been terminated. This can be done by briefly turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
2) Screw of the container and empty it. Pull out the suction tube with container seal.
3) Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1, C).
6
Perfect Spray 800 spray attachment