Viscosity Table; Interruption Of Work - WAGNER W550 Mode D'emploi

Detail / Radiator spray attachment
Sprayed material
Thinner-soluble primers
Thinner-soluble varnishes
Water-soluble primers
Water-soluble varnishes
Wood preservatives, strippers, oils
Disinfectants, plant protectants
Automobile spray paint
Adjusting the material quantity
The extension nozzle allows you to spray into very narrow spaces. To prevent
paint runs on the object, first adjust the paint quantity by spraying onto a piece of
card or paper from the same spraying distance.
First turn the adjustment knob (Fig. 1, pos. 10) fully to the left (-) and then slowly
increase the material quantity to the desired amount by turning it to the right (+).
Cover areas that are not to be sprayed.
•
CAUTION!
The units may only be used with a functional valve.
If paints rises in the ventilating hose (Fig. 1 A, item 15) do not
operate the unit further! Dismantle and clean the ventilating hose,
valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun!
Tips for painting points to which access is difficult
Cover all surfaces not to be sprayed. On furniture and objects with cavities, narrow spaces
and other points to which access is difficult, always work from the inside outwards. When
doing so, first paint the points to which access is difficult and the inner. Less visible surfaces,
then gradually work out towards the outer surfaces.
Tips for radiator painting
Allow the radiator to cool down before painting.
Pre-treat the radiator in accordance with the paint manufacturer's instructions. Start
painting in the spaces. First paint one side of the spaces. Move the gun in even upward
and downward strokes. Paint the other side after allowing the paint to dry for a short
time. This prevents the air tube coming into contact with wet paint. From time to time,
remove any paint particles from the air cap and nozzle using a damp cloth. Finally, paint
the outer surfaces from a greater distance and using more material. The standard spray
attachment can of course also be used for this.

Interruption of Work

i
When processing 2-component varnishes, clean the device immediately.

Viscosity Table

W550
25-30
15-30
25-30
20-25
undiluted undiluted undiluted undiluted
undiluted undiluted undiluted undiluted
20-25
Runout Time in Seconds
W560 W660
30-40
30 - 45
20-45
20 - 45
30-40 30 - 45
20-35
20 - 40
20-35
20 - 40
GB
W860/
PP213
40-60
30-60
40-60
30-55
30-55
7