Interruption Of Work; Shutting Down And Cleaning - WAGNER WALL EXTRA I-SPRAY 1300 Mise En Service

Wall Extra I-Spray 1300
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 5).
Interior wall paint in strong colour shades should be applied at least twice
i
(allow first paint coat to dry first). This will ensure good coverage.
For further information on setting the spray pattern and the correct spraying
technique refer to the instructions of the basic device.

Interruption of Work

•
Turn the machine off.
•
During longer breaks, vent the container by briefly opening and then closing it again.
•
Clean nozzle openings after an interruption in operation.
Make sure that the container is secure when setting down the spray
i
attachment.

Shutting down and cleaning

Please also refer to the instructions of the basic device.
1. Switch the unit off.
2. Unscrew the container and empty it. Pull out the suction tube with container seal.
3. Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1, C).
4. Pour water or solvent into the container. Screw the container back on.
Do not use flammable materials for cleaning purposes.
5. Turn on the machine and spray the solvent or water into a container or a cloth.
6. Repeat the above procedure until the water or solvent emerging from the nozzle is
clear.
7. Turn off the machine and remove the plug.
8. Unscrew the container and empty it. Pull out the suction tube with container seal.
We recommend the use of a common household washing-up brush to clean
i
the container.
CAUTION! Never clean seals, diaphragm and nozzle or air
holes of the spray gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
9. Pull the ventilating hose (fig. 1 A, 14) at the top from the gun body. Screw off the valve
GB
9