General Instructions - WAGNER W550 Mode D'emploi

GB
Before using the attachment, read these operating instructions and familiarise
yourself with the operating instructions for the basic unit. The safety instructions
for the basic unit apply to this radiator/detail spray attachment.

General instructions

The radiator/detail spray attachment was developed for applying water-soluble
and low-viscosity materials containing solvents.
The spray jet is deflected by 25° at the end of the 22 cm nozzle extension.
This allows problem-free coating of narrow spaces or points that are difficult
to reach.
1) Gun body
3) Needle
5) Paint tube
7) Turning aid
9) Air cap
11) Trigger guard
13) Feed tube
15) Ventilating hose
17) Diaphragm
Assembly (Fig. 1-4 )
Clip the needle onto the needle holders from above. (Fig. 2 A+ B)
Carefully attach the paint tube followed by the air tube (Fig. 3), and secure with the union nut.
Attach the air flap to the air tube. The position of the arrows must correspond. (Fig. 4 A+
B)
Align the feed tube (see instructions for the basic unit)
Spray on the container contents until there is very little remaining.
For spraying work with objects lying down, turn the feed tube forwards.
For spraying work on objects above head height, turn the feed tube to the rear.
Adjusting the spraying direction (Fig. 5 )
The rotary aid on the air tube always points in the same direction in which the spray jet is
deflected. To adjust the spraying direction, turn the air tube in the desired direction with
the union nut slightly undone. Then tighten the union nut again.
Preparing the Coating Material
The paints usually need to be diluted for use with the spray gun. You can find
information on spray consistency for dilution on the material container or in the
respective manufacturer's data sheet (e.g. available on the Internet).
Otherwise, use the data in the viscosity table below as guide values (viscosity = consistency
of the coating material).
Measuring the Viscosity (Fig. 6)
1. Stir the coating material thoroughly before measuring.
2. Dip the viscosity test cup (18) completely into the coating material.
3. Hold the test cup up and measure the time in seconds until the liquid empties out.
6
Detail / Radiator spray attachment
Description (Fig. 1+6)
2) Needle holder
4) Nozzle seal
6) Air tube
8) Union nut
10) Material quantity regulation
12) Container seal
14) Container
16) Valve cover
18) Viscosity test cup