Shutting Down And Cleaning - WAGNER WOOD&METAL EXTRA DETAIL Mode D'emploi

GB

Shutting down and cleaning

Please also refer to the instructions of the basic device.
1) Switch the unit off. Vent the container in case of longer breaks and after the work has
been terminated. This can be done by briefly turning open and then closing the container
or by pulling the trigger guard and letting the paint into the original paint container.
2) Screw of the container and empty it. Pull out the suction tube with container seal.
3) Preclean the container and feed tube with a brush. Clean the ventilating bore
(Fig. 1, C).
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
4) Pull the ventilating hose (Fig. 1 A, 12) at the top from the gun body. Screw off the valve
cover (13). Remove the diaphragm (14). Clean all the parts carefully.
5) Unscrew the union nut and remove the air cap and nozzle. Clean the air cap, nozzle
seal and nozzle with a brush and solvent or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig. 1A, 14).
1) Place the diaphragm (Fig. 1A, 14) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2) Place on the valve cover (Fig. 1A, 13) and screw it closed.
3) Place the ventilating hose (Fig. 1A, 12) on the valve cover and on the nipple at the
gun body.
4) Push the nozzle seal (Fig. 1B, 3) over the needle (2); the groove (slot) should point
towards you.
5) Put the nozzle (Fig. 1B, 4) onto the gun body and find the correct position by turning it.
6) Put the air cap (Fig. 1, 5) onto the nozzle (4) and tighten it using the union nut (6).
7) Place the container seal from below on the suction tube and slide it over the collar,
while turning the container seal slightly.
8) Insert the suction tube with container seal in the gun body.
8
Detail spray attachment