Interruption Of Work; Shutting Down And Cleaning - WAGNER WOOD&METAL EXTRA Mode D'emploi

GB
time. This prevents the air tube coming into contact with wet paint. From time to time,
remove any paint particles from the air cap and nozzle using a damp cloth. Finally, paint
the outer surfaces from a greater distance and using more material. The Standard spray
attachment can of course also be used for this.

Interruption of Work

When processing 2-component varnishes, clean the device immediately.
i

Shutting down and cleaning

1. Pull out the mains plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briefly turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2. Disassemble the gun.
3. Unscrew the container. Empty the rest of the coating material back into the can.
4. Pre-clean the container and feed tube using a brush. Clean the ventilating bore (Fig.1C).
5. Fill the container with solvent or water. Screw on the container.
Do not use flammable materials for cleaning purposes.
6. Reassemble the gun.
7. Plug in the mains plug, switch on the unit and spray solvent or water into a container
or onto a cloth.
8. Repeat the above procedure until clear solvent or water comes out of the nozzle.
9. Switch off the unit and pull out the mains plug.
CAUTION! Never clean seals, diaphragm and nozzle or air holes of the spray
gun with metal objects.
The ventilation hose and diaphragm are only solvent-resistant to a
limited extent. Do not immerse in solvent, only wipe.
10. Pull the ventilating hose (Fig.1A, pos. 15) at the top from the gun body. Screw off the
valve cover (16). Remove the diaphragm (17). Clean all the parts carefully.
11. Unscrew the union nut, then carefully pull off the air cap, air tube and paint tube.
Unclip the needle from the needle holder (Fig.2, C). Depending on the paint type, use
solvent or water and a brush to clean all parts of the extension.
12. Wipe the outside of the spray gun and container with a cloth impregnated with solvent
or water.
Assembly
The unit may only be operated with an integer diaphragm (Fig.1A, 17).
1. Place the diaphragm (Fig.1A, 17) with the pin facing upwards on the bottom section
of the valve. Also see the marking on the gun body.
2. Place on the valve cover (Fig.1A, 16)and screw it closed.
8
Corner&Reach spray attachment