Emptying The Used Products Of The Drawer; Cleaning The Drawer - NSK iCare+ Mode D'emploi

4.2.3. Emptying the used products of the drawer

Figure 25: Removal of the
drawer of iCare+ device
First start removing the drawer from its housing by sliding it backwards (see Figure 25) and secondly to dispose of
the used products, undo the clips to remove the tray from the drawer (see Figure 26).
Figure 26: Removal of the tray clips and of the
drawer's tray

4.2.4. Cleaning the drawer

To avoid the creation of some residues or else to remove them, it is advised to clean regularly the drawer. According
to the table 2 of part 4.1, the frequency for tray's cleaning should be weekly.
iCare+ User Manual V11.4 • 09/2017
The drawer should regularly be emptied. The emptying of the drawer is done after
each use, at the end of the day.
In parallel when the drawer is full, the corresponding LED on the Control panel is lit.
Tray + Drawer
All the products used for the treatment cycle of iCare+ device : Oil and especially the
n.Clean and n.Cid solutions are formulated to be disposed of in the sewage disposal
Figure 27: Tray and drawer after removal
p. 32