Launching The Cycle - NSK iCare+ Mode D'emploi

To restart the unit, first open the door, remove the instrument (to reduce the remaining pressure) reconnect the
instrument, and then close the door.
If the problem happens again, remove the handpieces and push the button "Start".
Check the instruments (in case of possible blocked channels).

3.5.6. Launching the cycle

Once the program is chosen, press START button to launch the cycle (see Figure 22).
iCare+ User Manual V11.4 • 09/2017

START button allows starting the programmed cycle for the selected
instruments. If a problem happens, or that you wish to stop the unit during a
cycle, START button allows also stopping the unit by a long press.
The cycle is then stopped, the settings and selections are kept and the
machine stays in standby. By pressing again START button, the cycle is
relaunched from the beginning with the kept settings.

If the door is open while the unit is in standby, the settings and selections
are initialized.
Figure 22: Launching the treatment cycle
If the user needs to stop the cycle during process, a long press on "START" button
will stop the unit.
p. 28