Assembly - Burkert 2000 Mode D'emploi

5.5.2

Assembly

Rebuild packing gland set based according to the drawing:
→
Lubricate new wiper
→
Lubricate individually chevron seal
→
Only for actuator size C: Assemble packing gland set
sequence (see detailed drawing).
→
Only for actuator size D, E, F, G, H: Assemble packing gland set
right sequence (see detailed drawing).
Actuator size C
18
36
37
14
11
15
13
Figure 2: Packing gland set
→
Push packing gland into the tube
gland set with screw
→
Only for actuator size C: Lubricate lip seal
36
O-ring on screw.
→
Mount actuator body
18
→
Screw with socket spanner; ensuring that the disk springs
→
Lubricate spindle
spindle thread.
For information about the assembly sleeve see chapter "10 Installation tools".
→
Insert spindle through nipple
12
7
with silicone grease OKS 1110-3 and insert into the tube
13
liberally with silicone grease OKS 1110-3.
10
16
7
8
as far as the stop; clamp nipples
18 18
. Remove screw
12 17
, disk springs and screw
2
lightly with silicone grease OKS 1110-3 and insert suitable assembly sleeve over
6
into actuator and remove assembly sleeve.
english
7 13 14 15
, , ,
7
,
Actuator size D, E, F, G, H
Pressure rings
7
Wiper
again.
37
lightly with silicone grease OKS 1110-3. Place lip seal and
18 8
on the tube
17
are in a central position.
Type 2000, 2002, 2012
Replacingthesealset
8
.
16 8
, in the tube in the right
13 15 16 8
, , in the tube
Chevron seal
16
Pressure spring
Chevron seal
6
to do this and screw in packing
.
in the