Fault Finding Guide - Dantherm CDF 40 Manuel D'entretien

Fault finding guide

Important!
Fault finding
More help
If the dehumidifier is not functioning correctly, shut it down immediately!
Use this table to localize and solve a possible problem or fault:
Fault
• The dehumidifier
does not work
• no light in the LEDs
on the display
• The compressor does not
work
• the display shows wrong
type
• The dehumidifier does not
work
If you cannot find the reason for the fault, switch off the unit immediately in order to prevent
further damage.
Contact a service technician or a Dantherm representative.
Possible cause
-
The compressor has stopped
automatically caused by a
too high temperature on the
condenser
Solution
• Check the external
fuses
• Check the power
supply to the unit
If the unit does not start again
after 45 minutes, check the
following:
• Check that the fan(s) is
running
• Check if the filter in the duct
kit is dirty, clean if necessary.
• Check if the condenser coil
is dirty
• Check if the room tempera-
ture is higher than 32 °C. If the
room temperature is higher
than 32 °C, the unit must be
stopped
• Check that the duct
openings are not covered
Check the built-in or the exter-
nal hygrostat, if any, by setting
it to a low relative humidity,
e.g. 10 – 20 %RH.
If the unit still does not start,
check the built-in or external
hygrostat for defects.
EN
23