Dantherm CDF 40 Manuel D'entretien page 39

Alarms
Ambient condition
Stand-by mode 2
Press for 3 seconds to enter
user menu setup.
Press for 5 seconds
to enter installer
menu setup
Sensor fail
Press to see which sensor
is defect.
Press to see which sensor
is defect.
Condensor sensor fail
DRC1 enters stand-by mode 2 when ambient conditions are out of operation range.
The display will show temperature and Rh readings when the unit is in stand-by mode 1.
This state will only get corrected when the ambient temperature (abt) or ambient humidity (abrh)
is in range, and can not be dismissed.
You can enter menu setup to modify set point values – only in this case.
While in Menu Setup, the alarm icon turn off and set point value will be shown instead of
"Abt/Abrh" code on INFO line
Dehumidifier is stopped because sensor failure is detected.
Sensor Fail can not be dismissed from DRC1.
Use UP or DOWN button to see which sensor/sensors are defect
If all sensors are defect these codes show in the following sequence: "COnd"
It is not possible to enter menu setup to modify set point values
If condenser sensor is defected, then "COnd" code will be shown when pressing UP or DOWN
when screen shows Sensor fail code "SEnS".
If no buttons pressed within 10 seconds then screen will again show "SEnS".
It is not possible to enter menu setup to modify set point.
EN
"EVAP" "RH/T"
39