Fault Finding Guide - Dantherm CDF 35T Série Manuel D'entretien

Fault finding guide

Important!
Fault finding
More help
22
If the dehumidifier is not functioning correctly, shut it down immediately!
Use this table to localize and solve a possible problem or fault:
Fault
-
• The
dehumidifier
does not work
• No light in the
LEDs on the
display
The compressor
• The compressor
has stopped
does not work
automatically
• The triangle is
caused by a too
constantly red
high temperature
on the condenser
The room
• The
temperature is
dehumidifier
lower than 3 °C and
does not work
the dehumidifier
• The thermome-
has been switched
ter LED on the
off automatically
display is lit in
red
-
• The
dehumidifier
does not work
• The lighting on
the display is
green
If you cannot find the reason for the fault, switch off the unit immediately in order to
prevent further damage.
Contact a service technician or a Dantherm Air Handling representative.
Possible cause
• Check the external fuses
• Check the power supply to the unit
If the unit does not start again after 45
minutes, check the following:
• Check that the fan(s) is running
• Check if the filter (CDF-T: in the duct
• Check if the evaporator and the
• Check if the room temperature is
• Check that the front cover panel
Wait till the temperature has increased
to more than 3 °C
Check the built-in or the external
hygrostat, if any, by setting it to a low
relative humidity, e.g. 10 – 20 %RH.
If the unit still does not start, check the
built-in or external hygrostat for defects
Solution
kit) is dirty
condenser coil is dirty
higher than 30 °C. If the room
temperature is higher than 30 °C, the
unit must be stopped
(CDF)/duct openings (CDF-T) are
not covered