Dantherm CDF 40 Manuel D'entretien page 32

EN
Water heating coil for CDF dehumidifier - mounting
Installation procedure
1. Remove front cover
3. Punch out the two discs in the rear of the unit. Slide heating
coil into place.
5 Secure heating coil with two screws left and right front.
7. Loop the flexible hose to avoid sharp bends..
32
2. Pre-assemble gaskets, fittings and flexible hoses.
4. Connect hoses to external heating source.
Note: the hoses run through the wall behind the unit
6. Cut along dotted lines and fit grommet around flex hose.
Push grommet and hose in place using liquid detergent for
lubricant.