Publicité
Les langues disponibles
Les langues disponibles
LEVIGABORDI – EDGE SANDER – PONCEAUSE -
Danger:
Incorrect connection to the mains supply constitutes a risk of electric shock.
To prevent electric shock always use three-pole mains supply connected to a
suitable electrical earth.
For maximum shock protection use a mains supply fitted with a differential cut-
out switch.
Danger:
Tampering in any way with the earth pin may cause electric shock.
Do not cut, remove or break the earth wire.
Do not try to fit a three-pin plug into anything other than a three-pin socket.
If the plug doesn't fit the socket, contact an authorised electrician.
Danger:
Using the machine with a damaged plug or mains lead constitutes a risk of
electric shock.
If leads or plugs are worn or damaged in any way, have them replaced by the
manufacturer, a K&T authorised dealer or qualified personnel to minimise risk.
MAINS LEADS, EXTENSIONS AND PLUGS
Use only approved three-ply cable with live, neutral and earth.
Maximum recommended mains lead length 10 m. For lengths over 10 m use heavier cable
section.
Danger:
Using mains leads with inadequate section and/or of excessive length may result
in damage and/or personal injury.
SINGLE PHASE MOTOR MACHINE 230 V∼ 50/60 Hz
For Europe the mains lead must be HAR approved type HO5VV-3x2.5 mm
be approved type 2P+T 16A 200-250V.
For non European versions talk to an authorised K&T dealer
ASSEMBLY INSTRUCTIONS (AFTER TRANSPORT)
To reassemble the machine after transport, proceed as follows:
1. Remove the centring pin (3, fig. 2) from the drum inside the handle (7, fig. 4) by
turning the handwheel in an anti-clockwise direction (4, fig. 2);
2. Insert the base of the handle vertically between the two shoulders of the motor base
(fig. 4), until it touches the centring reference (fig. 4);
3. Insert the centring pin in the reference holes in the two shoulders and complete
insertion by turning the handwheel in a clockwise direction until it blocks;
4. Connect the motor compartment power supply plug and block the safety mechanism (6,
fig. 3).
Caution:
The electrics box must face the rear of the machine. Keep the handle vertical
with respect to the base so that the microswitch (5, fig. 3) on the base is
pressed.
The centring pin needs to be inserted completely to guarantee machine control
during operation.
Danger:
Using the machine completely disassembled may cause injury to persons and/or
damage to things.
Do not use the machine when partially disassembled.
Keep all guards securely closed.
Keep the machine adjusted according to specifications.
1. Assemble the handle vertically.
2. Connect the power cable between the machine and a mains power socket.
MANUALE DI ISTRUZIONE – USE AND MAINTENANCE HANDBOOK – MANUEL POUR L'EMPLOI - BEDIENUNGSAINLEITUNG
BORDERSHLAUFMACHINE
BLIZZARD
ED.07
Pag. 16/40
2
and the plug must
Publicité
Chapitres
