Publicité
Les langues disponibles
Les langues disponibles
LEVIGABORDI – EDGE SANDER – PONCEAUSE -
SANDING DISK CENTRING PROCEDURE
The sanding disk must be centred manually on the drive disk.
Warning: The sanding disk is in the correct position when the motor base does not oscillate
eccentrically.
CHANGING SANDING DIRECTION
To change the direction of rotation proceed as follows:
1. Raise the handle to turn the machine to the right.
2. Lower the handle to turn the machine to the left.
3. Balance the handle to keep the machine in the desired position.
4. Push the machine forwards to advance.
5. Pull the machine backwards to reverse.
HAND GRIP HEIGHT ADJUSTMENT
Warning: Do not try to change the height of the handle when the machine is operating as this
may destabilise it.
RPM ADJUSTMENT FOR BRUSHLESS MOTOR
Warning:
Set desired speed before starting. Turn the switch to the appropriate position
depending on the application required and according to the scale indicated.The
switch has 9 positions (numbered from 1 to 9), corresponding to RPM values in
the range 80-100 rpm (position 1) to 450-500 rpm (position 9). These minimum
and maximum values are subject to a certain amount of variation according to
the different accessories the machine can be equipped with.
The machine requires no user performed maintenance. For any queries regarding repairs,
spare parts or accessories apply to an authorised Service Centre or direct to head office in
Cinisello Balsamo, Milan, Italy.
Always use original K&T spare parts. The guarantee and all consequent liability will be forfeited
if non-original K&T parts are used or repairs are carried out by unauthorised persons.
MANUALE DI ISTRUZIONE – USE AND MAINTENANCE HANDBOOK – MANUEL POUR L'EMPLOI - BEDIENUNGSAINLEITUNG
BLIZZARD
PERIODIC MAINTENANCE
REPLACEMENT PARTS
BORDERSHLAUFMACHINE
ED.07
Pag. 20/40
Publicité
Chapitres
