Table des Matières
Publicité
16
Installation
Supports à clouer
Le foyer a clouer supports des deux côtés. Fixez le foyer au cadrage.
REMARQUE: Assurez-vous que le foyer est carré et d'aplomb quand il est placé dans la charpente.
Mesurée coin à coin de la cheminée doit être carré (environ 47-1/8 » 1197mm). Voir l'illustration ci-
dessous. Utilisez des cales pour assurer la cheminée est carrée.
There are four nailing brackets
on the front of the fireplace.
Follow the directions below to
prepare the nailing brackets.
Once in place, nail or screw the
nailing brackets to the framing.
NOTE: Additional nailing
brackets are provided along
the base of the fireplace.
Use these brackets if not
using the front brackets.
1/2" (13mm)
Drywall
For installations using
1/2" (13mm) facing fold
the larger tab out 90°
(use a screwdriver if
necessary).
5/8" (0.625mm) Drywall
For installations using
5/8" (0.625mm) drywall
fold the shorter tab out
90° (use a screwdriver if
necessary).
© Travis Industries
(pour des installateurs qualifiés seulement)
4131120
WARNING:
Make sure the fireplace is
square and plumb when
placed in the framing.
Measured corner-to-
corner, the fireplace
should be square (approx.
47-1/8" (1197mm) for each
dimension). Use shims to
insure the fireplace is
square.
TOP VIEW
Fireplace
TOP VIEW
Fireplace
Framing
Nailing Bracket
Drywall
Framing
Nailing Bracket
Drywall
100-01364_FR
Publicité
Table des Matières
