Before Making Hook-Ups; Electrical Hook-Ups - Pelgrim MAG592RVS/P03 Notice D'utilisation

Before making hook-ups

Warning:
Ensure that your appliance has not suf-
fered any damage during transport (deformed
seal or door, etc.). If you see any kind of dam-
age, before doing anything else, contact your
retailer.
In order to easily locate the reference informa-
tion for your appliance, we recommend that
you note these data on the "After-Sales Service
Department and Customer Relations" page.

Electrical hook-ups

Ensure that:
- The electrical installation has sufficient volt-
age.
- The electrical wires are in good condition.
- The diameter of the wires complies with the
installation requirements.
- Your electrical installation is equipped with 16-
ampere thermal-sensitive protection.
In case of doubt, consult your electrician-
installer.
The electrical connections are made before the
appliance is installed in its housing.
Electrical safety must be provided by a correct
build-in. During installation and maintenance
operations, the appliance must be unplugged
from the electrical grid; fuses must be cut off
or removed.
The oven must be connected with a power
cable (standardized) with three 1.5 mm² con-
ductors (1 ph + 1 N + ground) that must be con-
nected to a monophase 220-240 V ~ network
via a CEI 60083 standardised receptacle (1 ph
+ 1 N + ground lead) or in accordance with
installation rules. The safety wire (green-yellow)
is connected to the appliance's O terminal and
must be connected to the ground lead of the
electrical set-up.
In the case of connections with an electric
receptacle, it must remain accessible after
installation of the appliance.
The oven's neutral conductor (blue wire) must
be connected to the network's neutral conduc-
tor.
In the electrical hook-up, ensure there is a
means available to the user, who must be able
to disconnect the appliance from the outlet,
either by pulling the plug from the outlet or by
turning off a switch, in compliance with instal-
lation rules.
If the power cable is damaged, it should be
replaced by the manufacturer, its after-sales
service department or by a qualified person to
avoid danger.
Warning:
We cannot be held responsible for any
accident resulting from a non-existent, defec-
tive or incorrect ground lead.
If the oven malfunctions in any way, unplug the
appliance or remove the fuse corresponding to
the electrical outlet where the oven is hooked
up.
It is dangerous for anyone other than a quali-
fied person to perform maintenance opera-
tions or repairs requiring the removal of the
cover that protects against exposure to micro-
wave power.