Before Using Your Appliance; Use - Pelgrim NF1100 Notice D'utilisation

Before using your appliance

Gashob
Burning in of the enamel
■
The burners cause the saucepan supports
to get extremely hot. In time the enamel on
the support points can burn in. This cannot
be prevented and is not covered by the
guarantee.
Burner caps
■ Check regularly whether the caps of the
burners are properly in position on the
burner depressions. Improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.
Oven
Prepare for use
■ Remove the sticker from the glass panel in
the oven door.
■ Remove the blue protective foil from the
stainless steel door.
■ Remove all accessories from the oven
and clean them thoroughly using a dish-
washing detergent. Switch on the closed,
empty oven at the maximum temperature
for about thirty minutes, after which the
grilling element should be switched on for
a period of fifteen minutes. Let the oven
cool off and clean it with warm water.
Please note:
When the oven is heated to a high
temperature for the first time, you will smell
a "new appliance" odour. This is to be
expected.
Clock
If you have not set a time, 0.00 and the word
"AUTO" will blink.
Setting the time
■
There is a normal clock on the display that
shows the time. Press the
at the same time.
■ Press the –/+ buttons until the correct time
is reached. "AUTO" keeps blinking.
■ Press the button. The time has been set
and the appliance is set to manual control.
fig. 1
and buttons