Specifications - Franklin Electric SUBDRIVE UTILITY UT2W 5870202003 Serie Manuel Du Propriétaire

SPECIFICATIONS

Model No.
Input from Power Source
Output to Motor
Pressure Setting
Operating Conditions
Controller Size
For Use With
NOTE: Drive input
voltage and motor nameplate
voltage MUST match.
SubDrive Utility
NEMA 3R (indoor/outdoor)
Voltage
Phase In
Frequency
Current (max.)
Power Factor
Power (idle)
Power (max.)
Wire Gauge Sizes
Voltage
Phase Out
Frequency Range
Current (max.)
Wire Gauge Sizes
Factory Preset
Adjustment Range
Temperature
Relative Humidity
NEMA 3R
Pump (60 Hz)
FE 230 V Motor
(Requires 230 VAC Input)
FE 115 V Motor
(Requires 115 VAC Input)
115/208/230 +/- 10% VAC
See Table 1, page 15; consult Federal, State, and Local codes for branch circuit installations.
Variable based on frequency
Single-phase, 2-wire
13.1 A (based on motor SFA)
See Table 2, page 15; consult Federal, State, and Local codes for branch circuit installations.
Pressure Sensor: 25–80 psi (0.3–6.6 bar)
Analog Transducer: 5–95% of transducer range
-13 °F to 122 °F (-25 °C to 50 °C)
20–95%, non-condensing
11-7/8" x 8-7/8" x 5-1/8" : 7.7 lbs
(30 x 23 x 13 cm : 3.5 kg)
1/3 hp, 0.25 kW with 244502- series motor
1/2 hp, 0.37 kW with 244504- or 244505- series motor
3/4 hp, 0.55 kW with 244507- series motor
1.0 hp, 0.75 kW with 244508- series motor
1.5 hp, 1.1 kW with 244509- series motor
244505- series (1/2 hp, 0.37 kW), 230 VAC, single-phase, 2-wire
244507- series (3/4 hp, 0.55 kW), 230 VAC, single-phase, 2-wire
244508- series (1.0 hp, 0.75 kW), 230 VAC, single-phase, 2-wire
244309- series (1.5 hp, 1.1 kW), 230 VAC, single-phase, 2-wire
244502- series (1/3 hp, 0.25 kW), 115 VAC, single-phase, 2-wire
244504- series (1/2 hp, 0.37 kW), 115 VAC, single-phase, 2-wire
5870202003
Single-phase
60/50 Hz
20 A
~0.52
3 W
2.5 W
35–63 Hz
50 psi (3.4 bar)
27