Typical Installation - Franklin Electric Inline Constant Pressure System Manuel Du Propriétaire

Inline Constant Pressure System
FIGURE 1:

Typical Installation

The Inline System is designed to both increase a system's incoming pressure and to provide the
system with constant pressure across all outlets. See FIGURE 2 for a graphical representation of
what a typical installation may look like.
FIGURE 2:
Water Supply
Ball
*Check
Valve
Valve
Optional Bypass
*NOTICE: If system plumbing does not have a backflow prevention device, a check valve is required on the
incoming water supply line.
NOTE: These optional components are shown in a typical installation diagram. They should be used at the
installer's discretion as required for particular applications.
MOTOR OVERLOAD PROTECTION NOTE: The drive electronics provide motor overload protection by
preventing motor current from exceeding the maximum Service Factor Amps (SFA). Motor over-temperature
sensing is not provided by the drive.
10
3.45"
10.43"
[ 87.7 ] [ 265 ]
1-1/4" NPT/BSPP
SUCTION
Inline System
Union
Flow
Coupling
Ball
Valve
ACCESS PANEL
ACCESS PANEL SCREWS
18.84"
[ 478.5 ]
17.32"
[ 439.9 ]
5 feet or Less
2 Gallon
Power
Tank
Union Check Pressure
Coupling Valve Shut-o
(optional)
Check
Valve
1.50"
[ 38.1 ]
INPUT
POWER
1-1/4" NPT/BSPP
DISCHARGE
Pressure
Sensor
Pressure
Gauge
Ball
Pressure
Valve
Relief
Valve
To Home
(Discharge into drain
rated for max pump
output at relief pressure)