Typical Installation - Franklin Electric Inline 1100 Manuel Du Propriétaire

Figure 1:

TYPiCAL iNSTALLATiON

The Inline System is designed to both increase a system's incoming pressure, and to provide the system with constant
pressure across all outlets. See Figure 2 for a graphical representation of what a typical installation may look like.
Figure 2:
Water Supply
Ball
*Check
Valve
Valve
Optional Bypass
*NOTiCe: If system plumbing does not have a backflow prevention device, a check valve is required on the incoming
water supply line.
NOTe: These optional components are shown in a typical installation diagram. They should be used at the installer's
discretion as required for particular applications.
4
3.45" 10.43"
[ 87.7 ] [ 265 ]
1-1/4" NPT
SUCTION
Inline System
Union
Flow
Coupling
Ball
Valve
ACCESS PANEL
ACCESS PANEL SCREWS
18.84"
[ 478.5 ]
17.32"
[ 439.9 ]
5 feet or Less
Power
Union Check Pressure
Coupling Shut-off
Valve
Switch
(optional)
Check
Valve
1.50"
[ 38.1 ]
POWER
1-1/4" NPT
DISCHARGE
Pressure
2 Gallon
Switch
Tank
Pressure
Gauge
Pressure
Relief
Valve
(Discharge into drain
rated for max pump
output at relief pressure)
INPUT
Ball
Valve
To Home