Key Features; Inspect Your Shipment - Franklin Electric Inline Constant Pressure System Manuel Du Propriétaire

Inline Constant Pressure System
Inline System Key Features
System Features:
• Constant water pressure with a wide range of settings (25-80 psi, 1.7 - 5.5 bar)
• Pump speed is controlled to provide the optimum performance without overloading the motor
• Product Power Rating: 1.2 hp (0.9 kW)
• Low current motor start-up (soft-starting)
• Quiet operation
• Single pump/motor/drive controller design
• Compact footprint, 19 in x 8 in (480 mm x 200 mm)
• Shipping weight: 50 lbs (22.7 kg)
Pump Features:
• Operates on a wide range of flows from flooded suction to 35 gpm (135 lpm)
• Requires minimum incoming pressure of 3 psi (0.2 bar) Exception: Cisterns may be flooded
suction without vortexing
• Increases incoming pressure by up to 60 psi (4.1 bar)
• Stainless steel construction for all wetted surfaces
Drive Controller Protection Features:
• No in-rush (power-on transient) current
• Over-pressure shutoff optional (see Replacement Parts section)
• Low water shut-off
• Locked pump detection/shut-off
• Water over-temperature shut-off
• High voltage/lightning surge protection
• Low line voltage protection
• Motor under and overload protection
• Open and short circuit protection
• NEMA 4 enclosure

INSPECT YOUR SHIPMENT

All Franklin Electric Inline Systems are carefully tested, inspected, and packaged to ensure their
arrival in perfect condition. When the pump is received, examine it closely to make sure there is
no damage that may have occurred in shipping. If damage is evident, report this immediately to
your shipping carrier and product dealer. The shipping carrier assumes full responsibility for the
shipment's safe arrival. Any claim for damage to the shipment, either visible or concealed, must
be made through the shipping carrier first.
Package Includes:
• Inline 1100 Constant Pressure System pump and controller unit
• Pressure sensor and boot
• Sensor adjustment tool
• Installation manual
4