Publicité
RECOMMENDATIONS FOR USE OF FLAMAL GAS
Check the condition of the pipes every month and make sure they are changed every year.
7 - LIGHTING THE TORCHES
If the torches do not light within 5 seconds of the opening of the gas and/or the ignition command, stop the flow of
gas immediately and wait for about twenty seconds before repeating the operation. There is a risk of the build-up of
gas that may light up and/or lead to an explosion.
8 - AIRBORNE NOISE
1 - MEASUREMENT SITE QUALIFICATION
The machine was tested in the
ALWF ZI rue Lavoisier, BP009
79200 PARTHENAY FRANCE.
central assembly building
This site has been qualified by CETIM (Mechanical Industries
Technical Centre)
52, avenue Félix-Louat BP 67
60304 Senlis cedex FRANCE
This qualification was the subject of Report
n°4/028779/492.2A
The site is referenced in engineering grade : correction
factor K < 2dB
14
3 - MEASUREMENTS
The acoustic pressure values depend on the cutting
process used on the machine.
Refer to the instructions of the equipment installed to obtain
these values
The apparatus alone produces an acoustic pressure below
70 dB
2 - SOUND PRESSURE MEASUREMENTS
The values are given in equivalent weighted sound level
(LAeq)
The unit of measurement is the dB (A): weighted decibel "A"
The measurements were taken at a height of 1.5m above
the ground with an ACLAN soud-level meter, type SIP 95, nbr
934033, checked in accordance with our Quality Insurance
procedures ISO 9000
8695 7050
SAFETY
Publicité
Chapitres
Dépannage
