C - Electronic Programmer Operation; Setting The Time; Manual Operation - Porter & Charles SOPS76TM Mode D'emploi

C - Electronic Programmer Operation

oven function selector oven program m er oven therm ostat selector
09:05
A UTO
Caution
The electronic clock features Touch-Control technology.
To operate, simply touch the glass control symbols with your fingertip.
The touch control sensitivity continuously adapts to ambient conditions. Make sure the glass
surface of the control panel is clean and free of obstacles when plugging in the oven.
If the clock does not respond correctly when you touch the glass, unplug the oven for a few
seconds and then plug it in again. Doing this causes the sensors to adjust automatically so that
they will react once more to fingertip control.
Electronic Clock Settings
:
Symbol lights up when the clock timer is selected
Symbol AUTO: lights up to indicate that the oven is programmed.
:
Symbol indicated that the oven is transmitting heat to the food.
+/- Sensors: enable you to select a time.
:
Sensors enable you to programme the electronic clock functions.

Setting the Time

When you turn on the oven, you will see the clock flashing 12:00
Set the clock by touching the + or – sensor. You will hear 2 beeps confirming that the time
has been set.
To change the time, press the + and – sensors at the same time. The current time will then flash
on the screen. Change the time by pressing the + or – sensors. Two beeps will then confirm that
the new time has been set.
NOTE
The clock light has a night mode so the display light will be dim between 00:00 and 6:00 hours.

Manual Operation

After setting the clock, the oven is ready for use. Select a cooking function and temperature.
During cooking, symbol will light up to indicate that the heat is being transmitted to the food.
This symbol turns itself off when the selected temperature has been reached.
Set the controls to to turn off the oven.
7