Porter & Charles SOPS76TM Mode D'emploi page 19

Removing oven door (pull down door models only)
The oven door can be easily removed for better access while cleaning. To remove the oven door:
1. Open the door fully and fit the supplied pin in the holes in the hinges on each side.
2. Raise the door slightly, holding the sides of the door about half way up. Make sure
the pin stays in the hole the entire time. Lift the door gently. This should
disconnect the hinges from the oven frame.
3. Remove the door by continuing to raise it while pulling the door away from the oven.
When handling the door be careful not to dislodge the pin from the hole. If the pin
does dislodge, the hinge will have to be closed by hand and the pin re-fitted onto the
hole before re-fitting into the oven.
To re-fit the oven door:
i. Holding the door at an angle to the oven, slide the hinges into the oven frame,
making sure that on each side the top curved arm fits into the top slot and the lower
arm fits into the bottom slot.
ii. Make sure the hinges are pushed as far as they will go and the lower arm engages
into the plate mounted in the oven frame.
iii. Open the door fully and ensure the pin fully disengages from the hole. The door can
now be opened as normal.
Changing the light bulb
WARNING:
Ensure that the appliance is disconnected/switched off before replacing the lamp to avoid
the possibility of electric shock
The light bulb is located behind the glass cover and is a push-in design.
To change a light bulb:
1- Gently lever out the glass cover only.
2- Pull the light bulb and push in a replacement bulb.
3- Replace the glass cover making sure it fits correctly into place.
NOTE:
Recommended bulb: Halogen 40W / 230
19