Appendix A - CombiSteel 7469.1100 Mode D'emploi

Appendix A

Connecting the machine:
Type of the machine
МВ108, МВ109, ММ109, ММ111, ММ113, ММ115
МВ211, МВ214, МВ216, ММ218, ММ222, ММ226, ММ232
МВ211, МВ214, МВ216
The machine in the refrigerator should be carried out in the following order:
1. Before you start the machine:
- Cut an opening in the wall panel;
- Glue sealant (supplied with the machine) at the edge of the path, after cutting out of the protective film;
- Apply sealant around the circumference of the rod and the prepared opening.
2. Set the device to cut the gap chamber;
3. Install the ceiling of the camera and secure it.
4. After the installation of the machine:
- Attach the bracket hinge screw chiller: the bottom - on the side of the camera, the top - on the roof panel;
- Screw the drain pipe
- Set the lighting fixture to cooled volume.
МВ108, МВ109
www.combisteel.com
Dimensions, мм
А-A Б-B В-C Г-D
425 305 300 412
425 305 300 412
725 305 300 412
725 305 300 412
Д-E Е-F Ж-G
80 315 704
100 315 704
80 315 704
100 315 704
13