Replacing The Starter Rope And Rewind Spring - Stihl MS 200 Notice D'emploi

English
1
N Remove chain sprocket cover (1)
N Pull off the spark plug boot
N Unscrew spark plug
Checking the spark plug
N Clean dirty spark plug.
N
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
N Rectify the problems which have
caused fouling of the spark plug.
30
Possible causes are:
– Too much oil in fuel mix.
– Dirty air filter.
– Unfavorable running conditions.
If the spark plug comes with a
detachable adapter nut (1), screw
the adapter onto the thread and
tighten it down firmly to reduce
the risk of arcing and fire.
Installing the spark plug
N
Install the spark plug and connect
the spark plug boot (press it down
firmly) – reassembly all other parts
in the reverse sequence.
A
Replacing the Starter Rope
and Rewind Spring
Replacing the starter rope
1 1
1
N Remove screws (1)
N Lift the fan housing off of the
crankcase and pull it away to the
side
N Carefully press the spring clip (2) off
of the axle with a screw driver or
suitable pliers
N
Carefully remove the rope rotor with
washer (3) and pawl (4)
The rewind spring can jump out –
risk of injury!
1
1
MS 200