Replacing The Starter Rope And Rewind Spring - Stihl MS 251 Notice D'emploi

English
Installing the spark plug
Fit spark plug by hand
N
Tighten the spark plug and press on
N
the spark plug boot firmly
Fit the shroud – see "Shroud"
N
36
Replacing the Starter Rope
and Rewind Spring
Removing the fan housing
Remove the shroud – see "Shroud".
N
1
1
Take out the screws (1).
N
Push the hand guard upwards.
N
Pull the underside of the fan
N
housing away from the crankcase
and remove it downwards.
Removing the Rope Rotor
Versions with Easy2Start
If suitable circlip pliers are not available,
have the starter rope or rewind spring
replaced by your servicing dealer.
1
Use circlip pliers to carefully remove
N
the circlip (1).
Remove the washer (2), carrier (3)
N
and spring housing (4).
All versions with one pawl
1
Use a screwdriver or suitable pliers
N
to remove the spring clip (1) from
the starter post.
Carefully remove the rope rotor with
N
washer (2) and pawl (3).
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
4
3
2
1
2
3
1
MS 251, MS 251 C