F: Connecting To A Router Without Wps-Pbc Function - Pioneer XC-HM82-K Mode D'emploi

10
10
Note
• If your router does not have a built-in DHCP server function,
you have to set up the network manually.
 Select DHCP to be Off and press ENTER in step 7.
If your router does not have a built-in DHCP server function,
you have to set up the network manually.  Select DHCP to
be Off and press ENTER in step 4. on page 37
• When you connect this receiver to the Internet via a proxy
server, proxy server settings are required.
 Select Use Proxy Server and press ENTER in step 7.
<Proxy Server setting>
Then Enter Proxy Host Name and the port number of
your proxy server in the Proxy Port field.
F: Connecting to a router without WPS-PBC
function
This section describes how to set the network connection
using Web browser on a computer.
Be sure your computer is equipped with wireless LAN
function. Settings can be performed from the Web browser of
the computer.
1
Be sure the LAN cable is not connected to the receiver.
2 Plug the power cord into an AC outlet. Press STANDBY/
ON.
Press NET SERVICE  SETUP on the remote control.
3
Select Network Setting  Network Configuration 
4
Wireless  Web Control.
Select Start  OK.
5
The receiver restarts. Change settings on Web Control on
your computer.
6
Select Pioneer Setup (this receiver) in the available
wireless network connection of your computer.
SSID is displayed as Pioneer Setup:xxxxxx. "xxxxxx" is the
lower three bytes of the MAC address.
:xxxxxx
000001
000002
000003
Note
• Consult the appropriate operating instructions for
information regarding operation of the computer, iPhone,
tablet computer or other device used.
• Since this kind of connection is not encoded, a minor
security risk may be involved.
• This setting for the network has been confirmed for Mac OS
X 10.7 and Safari 5.1.
7 Start your computer's Web browser, and access the URL
noted below to make settings for this unit.
The Web Control menu will appear.
192.168.1.1
http://192.168.1.1
For Safari
Press Bookmark icon ( ) at the upper left of the
screen. Click Bonjour list (a), and then select this unit's
name ("Friendly Name") (b) in Bookmark.
Note
• "*****" is the lower three bytes of the MAC address.
a
b
XX.XX
Click Network Setup  Network Configuration. Select
8
Auto and then press OK.
9
Setup the network settings manually and then press
Apply.
If SSID is not displayed, return to step 9 and select
Manual.
The receiver restarts and the new network settings are applied
to the receiver.
Note
• You can set the network as in the above by connecting this
unit's IP address via the Web Browser even if Web Control
isn't selected.
Playback with NETWORK features
XC-HM82 *****
XC-HM82 *****
41