Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2
2
Antenna connection
Supplied FM wire antenna:
Connect the FM wire antenna to the FM 75 ohms socket and
position the FM wire antenna in the direction where the
strongest signal can be received.
External FM wire antenna:
Use an external FM wire antenna (75 ohms coaxial cable) for
better reception. When an external FM wire antenna is used,
disconnect the supplied FM wire antenna.
Supplied AM loop antenna:
Connect the AM loop antenna to the AM terminal. Position
the AM loop antenna for optimum reception. Place the AM
loop antenna on a shelf, etc., or attach it to a stand.
Note
•
Placing the antenna on the receiver or near the AC power
cord may cause noise pickup. Place the antenna away from
the receiver for better reception.
WLAN antenna connection
Connect the WLAN antenna to the WLAN ANTENNA
terminal.
Please always use the supplied WLAN antenna.
Speaker connection
•
You can use speakers with a nominal impedance between
4 ohms and 16 ohms.
CAUTION
•
These speaker terminals carry HAZARDOUS LIVE voltage.
To prevent the risk of electric shock when connecting or
disconnecting the speaker cables, disconnect the power
cord before touching any uninsulated parts.
•
Do not mistake the right and the left channels. The right
speaker is the one on the right side when you face the
receiver.
•
Do not let the bare speaker wires touch each other.
•
Make sure that all the bare speaker wire is twisted together
and inserted fully into the speaker terminal. If any of the
bare speaker wire touches the back panel, it may cause the
power to cut off as a safety measure.
Using other subwoofer
You can connect a subwoofer with an amplifier to the
SUBWOOFER PREOUT socket.
Audio cable
Audio signal
(commercially
available)
To audio input
socket
To SUBWOOFER
PREOUT socket
LAN (10/100)
DIGITAL
available subwoofer
IN
WLAN
OPTICAL
ANTENNA
ANTENNA
AM
LINE 1
IN
LINE 2
IN
LOOP
L
SUBWOOFER
PRE OUT
FM
UNBAL
R
75 Ω
Note
•
No sound is heard from the subwoofer without a built-in
amplifier.
Connecting a TV, etc.
Listening to digital audio
You can connnect TV and digital audio device to this receiver
using an optical cable (commercially available) (Connecting
your equipment on page 8).
To select Digital in function:
•
Press DIG IN on the remote controll or INPUT button
repeatedly on the receiver to select Digital In function.
Note
•
Digital signal formats that can be input to the stereo
receiver include linear PCM signals with sampling rate and
quantitative bits up to 192 kHz/24 bits. (Depending on the
connected device and environment, operation may not be
successful).
Listening to analog audio
Connect to the TV using an audio cable.
TV
To LINE input
sockets
Commercially
(amplifier built in)
SUBWOOFER
PRE OUT
To select Line function:
•
On main unit: Press INPUT button repeatedly until Line is
displayed.
•
On remote control: Press LINE1/2 button.
Connecting your equipment
To audio
AUDIO
output sockets
OUT
L
Audio cable
R
(commercially
available)
LAN (10/100)
DIGITAL
IN
WLAN
OPTICAL
ANTENNA
ANTENNA
AM
LINE 1
IN
LINE 2
IN
LOOP
L
FM
UNBAL
75 Ω
R
9
Publicité
Chapitres
Table des Matières
Dépannage
