A: Wired Setting; B: Connection Settings Using An Ios Device (With Ios 5.0 Or Later) - Pioneer XC-HM82-K Mode D'emploi

10
10

A: Wired setting

Make sure that the LAN cable connections has completed
(page 10).
Press NET SERVICE  SETUP.
1
The Initial Setup screen is shown on the display.
Select Network Setting  Network Configuration.
2
Use / to select Wired, then press ENTER.
3
Network Configuration
Wired
Wireless
Use / to select DHCP On, then press ENTER.
4
Select Don't Use Proxy Server.
Network Configuration
DHCP On
DHCP Off
Note
• If your router does not have a built-in DHCP server function,
you have to set up the network manually.
 Select DHCP to be Off and press ENTER in step 4.
<Manual setting>
Then use /// or numeric buttons to adjust the
numbers, then press ENTER.
IP Address
XXX . XXX XXX
. .
/: Moves the adjusting digit.
/: Increases or decreases values.
IP Address
The IP address to be entered must be defined within the
following ranges. If the IP address defined is beyond the
following ranges, you cannot play back audio files stored
on components on the network or listen to Internet radio
stations.
Class A: 10.0.0.1 to 10.255.255.254 / Class B: 172.16.0.1 to
172.31.255.254 / Class C: 192.168.0.1 to 192.168.255.254
Subnet Mask
If an xDSL modem or a terminal adapter is directly
connected to this receiver, enter the subnet mask listed in
your ISP documentation. In most of the cases, enter
255.255.255.0.
Default Gateway
If a gateway (router) is connected to this receiver, enter
the corresponding IP address.
Primary DNS Server/Secondary DNS Server
If there is only one DNS server address listed in your ISP
documentation, enter Primary DNS Server. In case there
are more than two DNS server addresses, enter
Secondary DNS Server in the other DNS server address
field.
• When you connect this receiver to the Internet via a proxy
server, proxy server settings are required.
 Select Use Proxy Server and press ENTER in step 4.
Playback with NETWORK features
<Proxy Server setting>
Then Enter Proxy Host Name and the port number of
your proxy server in the Proxy Port field.
B: Connection settings using an iOS device
(with iOS 5.0 or later)
You can apply iPod/iPhone/iPad (iOS device with iOS ver 5.0
or later)'s Wi-Fi settings to this receiver.
XXX
Note
• The iOS device and router must be connected at 2.4 GHz.
1
Be sure the LAN cable is not connected to the receiver.
2
Unlock your iPod/iPhone/iPad. Check that the Wi-Fi
mark is displayed on the iOS device.
3
Plug the power cord into an AC outlet. Press STANDBY/
ON.
4 Press iPod/USB on the remote control.
Connect the iOS device to the USB terminal.
5
Press SETUP.
Select Network Setting  Network Configuration 
6
Wireless  iOS Device and then press ENTER.
7 Tap Allow on iPod/iPhone/iPad.
The Wi-Fi settings of your iPod/iPhone/iPad are applied to
the receiver.
Share Wi-Fi Settings?
Ignore
37