Before You Start; About This Product; Checking What's In The Box; Loading The Batteries - Pioneer XC-HM82-K Mode D'emploi

Before you start

About this product

Network CD Receiver consists of the main unit.
5 V 2.1 A PHONES AUDIO IN ON TIMER

Checking what's in the box

Please check that you've received the following supplied
accessories:
• Remote control
• Power cord
• AAA size IEC R03 dry cell batteries (to confirm system
operation) x 2
• AM loop antenna
• FM wire antenna
• WLAN antenna x 2
• iPhone/iPad stand
• These operating instructions

Loading the batteries

The batteries included with the receiver have been provided to
allow you check product operation and may not last long. We
recommend using alkaline batteries that have a longer life.
WARNING
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a heater.
This can cause batteries to leak, overheat, explode or catch
fire. It can also reduce the life or performance of batteries.
CAUTION
• Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
Never use new and old batteries together.
-
Insert the plus and minus sides of the batteries properly
-
according to the marks in the battery case.
Batteries with the same shape may have different
-
voltages. Do not use different batteries together.
When disposing of used batteries, please comply with
-
governmental regulations or environmental public
institution's rules that apply in your country/area.
When inserting the batteries, make sure not to damage
-
the springs on the battery's  terminals. This can cause
batteries to leak or over heat.

Operating range of remote control

The remote has a range of about 7 m at an angle of about 30°
from the remote sensor.
30°
30°
7 m (23 ft.)
Keep in mind the following when using the remote control:
• Make sure that there are no obstacles between the remote
and the remote sensor on the receiver.
• Remote operation may become unreliable if strong sunlight
or fluorescent light is shining on the receiver's remote
sensor.
• Remote controllers for different devices can interfere with
each other. Avoid using remotes for other equipment
located close to this receiver.
• Replace the batteries when you notice a fall off in the
operating range of the remote.
5