Belt Adjustments; Console Operations - BH LK500Ti Guide D'utilisation

ASSEMBLY INSTRUCTIONS

BELT ADJUSTMENTS

To adjust the running belt, stop the treadmill,
then use the Hex Wrench and adjust the
Hex Screw located in the Rear End Cap. If
the running belt is moving towards the left
side, tighten the left Hex Screw about 1/4
turn (clockwise); if the running belt is moving
towards the right side, tighten the right Hex
Screw about 1/4 turn (clockwise); Turn the
treadmill on after it has been adjusted. If you
fi nd that the belt has not moved to the proper
position, please repeat the steps above. Don't
use the treadmill until the running belt returns
to the center position.
The position of running belt might not stay
precisely in the center, it can and will shift
slightly towards the left and right sides,
however, you do not need to adjust the belt if
it is not rubbing against the side rails.
Depending on the usage of the product,
please apply silicon according to the chart to
the right. Use the Hex Wrench to unscrew the
bolt inside the Rear Roller. Then pull the belt
up and put some silicon to the center of the
board. After that, adjust the belt to the center
of the deck, followed by tightening the screw
to the original set.
When the belt is sliding, please follow the
above method to lubricate the running board.
Register your product warranty online at: www.BHFitnessUSA.com
18
Questions regarding warranty and parts call: 636.634.2217
Silicon Chart
KGS/LBS Speed Interval
6KM/hr Below 1 year
6~12KM/hr 6 months
KGS 12KM/hr Above 3 months
4mile/hr Below 1 year
4~8mile/hr 6 months
LBS 8mile/hr Above 3 months
Note: This maintenance is intended for household use. If
used for business, it is suggested to examine the product
every other month.

CONSOLE OPERATIONS

Register your product warranty online at: www.BHFitnessUSA.com
Questions regarding warranty and parts call: 636.634.2217
19