Fitting The Top Tank; Fitting The Brush; Tipping The Brush Deck - Numatic TT 4045 Mode D'emploi

Fitting top tank
3

Fitting the brush

Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
The Pad is retained using Numatic's own PadLoc system (ask your supplier for details).
Only use manufacturer supplied brushes / pads.
TT 4045 requires a 450mm brush or a 400mm pad.
TT 4055 requires a 550mm brush or a 500mm pad.
5

Tipping the Brush Deck

7
!
Fit the top tank to the machine
(Fig.3).
Fit the brush / pad to the drive chuck,
Safety gloves are recommended for the changing of used brushes.
To tip the deck into the down position
(Operating mode): Press in the brush
deck locking pin (Fig.7) and rotate the
brush deck (Fig.8).
To change to brush deck up position,
(Transit mode) simply lift the deck
and the sprung loaded locking pin will
activate to hold the deck up.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
Machine Set Up
Fit both the vacuum hose and the
floor-tool hose to the separator
twist to lock the brush (Fig.5)
or pad in place (Fig.6).
18
4
(Fig.4).
6
8
!