Table des Matières
Publicité
Filling the clean-water tank
The TT Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single fill. To fill
the clean-water tank, use the FLEXI - FILL pipe from either a tap or hose pipe (Fig.16).
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Clean water level
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturer's specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit
http://www.hse.gov.uk/
!
Always ensure that chemical manufacturer's safety guidelines are followed.
!
Do not operate machine unless the Operator Manual has been read and fully understood.
Clean water tap
Machine Set-Up
The water level in the clean-water tank can be
seen using the clean-water clear dump hose
fitted to the rear of the machine.
The clean-water bottom tank holds 40 litres.
for UK information.
WHEN HANDLING AND MIXING CHEMICALS
Only use chemicals recommended for use in auto scrubber-dryers.
Turn on the clean water tap.
The large cap on the left can be
removed for filling from a bucket
or suitable container. (Fig.17).
Fill the clean-water tank to a
maximum of 40 litres, including
cleaning chemicals if required.
Follow chemical manufacturing
guide lines.
Note:
MAX
Important
22
Off
!
!
On
Publicité
Table des Matières
