Log Placement (Hd4St And Hd4P Only) - Napoleon HD4N Instructions D'installation Et D'utilisation

6.4

LOG PLACEMENT (HD4ST AND HD4P ONLY)

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
NOTE: The individual logs can be easily identifi ed by the numbers cast on the underside of each log.
Phazer logs and glowing embers exclusive to Wolf Steel Ltd., provide
TM
a unique and realistic glowing effect that is different in every installation.
During the initial use of the appliance, log colours may vary. During the
initial use of the appliance the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
NOTE: The pilot is located on the right end in these instructions.
1. Remove the doors, refer to the "DOOR REMOVAL / INSTALLATION
section for removal instructions.
2. Place the #1 log onto the one pin located on the corner of the burner,
on the left side, and the second pin located on the left end hearth
pad. Place one pin into the log, as shown in Figure 1.
3. Place the #2 log onto the pin located in the #1 log, it should rest in the
middle of the right side hearth pads as shown in Figure 2. Place one
pin into the middle of the #2 log, as shown in Figure 2.
4. Place the #3 log onto the pin located in the #2 log and let it rest on
the right side hearth pads, as shown in Figure 3 and in the right side
view below. Place one pin into the #2 log, as shown in Figure 3.
5. Place the #4 log onto the pin located in log #2 and let it rest on the
right end hearth pads, as shown in Figure 4 and in the left side view.
Place one pin into the right side hearth pad, as shown in Figure 4.
6. Place the #5 log onto the pin located in the right side hearth pad and
let it rest on the burner, as shown in Figure 5. NOTE: Ensure log #5
does not cover any burner ports.
7. Place the #6 log onto the pin located on the corner of the burner, on
the left side, then place one pin into middle of the log, as shown in
Figure 6. NOTE: Ensure log #6 does not cover any burner ports.
LEFT
SIDE
VIEW
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
10
6
7
8
5
2
WARNING
!
11
1
3 4
76.1A
PIN
Fig. 1
PIN
Fig. 2
PIN
Fig. 3
PIN
Fig. 4
Fig. 5
Fig. 6
PIN
W415-1146 / A / 02.16.13
35
EN