26
* When constructing the enclosure allow for fi nishing material thickness to maintain clearances.
This appliance is supplied with four stand-offs. For
EN
convenience the stand-offs have been shipped fl at and
located on the top of the appliance. Before framing
ensure the stand-offs are bent up and screwed into
place ensuring a height of 10" (254mm). Stand-offs are
not used for structural support
5.1
FRAMING
5.1.1 SEE-THRU FRAMING
NOTE: Dimension "A" should
measure 17 5/8" (447.7mm)
minimum (depending on the
fi nishing material thickness)
5.1.2 PENINSULA FRAMING
NOTE: Dimension "A" should
measure 17 5/8" (447.7mm)
minimum (depending on the
fi nishing material thickness)
NOTE: All framing dimensions are based on the fi nishing material supports position. Framing may change
depending on the fi nishing material thickness. (See "FINISHING SUPPORT ADJUSTMENT" section).
W415-1146 / A / 02.16.13
Bend and secure the stand-offs as
A
B
A
40
3
"
/
4
(1035.1mm)
A
38
3
"
/
8
(974.7mm)
STAND-OFFS
illustrated :
42
1
"
/
2
(1079.5mm)
42
1
"
/
2
(1079.5mm)
C