Finishing Support Adjustment - Napoleon HD4N Instructions D'installation Et D'utilisation

5.3.1 FINISHING SUPPORT ADJUSTMENT

Depending on the fi nishing material we have allowed
from 0" (0mm) to 3/4" (19mm) of adjustment after
the 1/2" (12.7mm) cement board has been installed.
Loosen the 8 screws on each fi nishing support.
Adjust the fi nishing support to the desired position.
NOTE: Peninsula models have one end support
that can also be adjusted by loosening the two
screws.
SIDE VIEW
NOTE: Framing dimension "A"
will be affected as the fi nishing
supports are adjusted outwards.
(Refer to "FRAMING" section".
FINISHING FINISH SUPPORT
MATERIAL POSITION
1/4" (6.4mm) 1/2" (12.7mm)
1/2" (12.7mm) 1/4" (6.4mm)
3/4" (19.1mm) Flush 0" (0mm)
29
1/2" Cement
Board
Finish support
1/4"
Finishing
Material
1/2" Cement
Board
Finish support
1/2"
Finishing
Material
1/2" Cement
Board
Finish support
3/4"
Finishing
Material
W415-1146 / A / 02.16.13
EN