finishing
EN
4.3
media installation
There are 2 media options for this appliance: log set and acrylic crystals. The log set assembly comes pre-
installed with the appliance and has to be finished with topaz glass (see "log set and topaz glass installation"
section). If desired, the log set and topaz glass can be switched out with acrylic crystals (see "acrylic crystal media
installation" section).
4.3.1 log set and topaz glass installation
Install the log set and topaz glass after framing the appliance and before installing the front glass.
If log set assembly is installed:
Carefully place the topaz glass between the log set assembly (front and back side).
A.
If acrylic crystal media is installed:
Ensure to remove all acrylic crystals from the ember bed.
A.
Remove fasteners from the media tray (Fig. 1).
B.
Remove media tray (Fig. 2).
C.
Install log set assembly (Fig. 3).
D.
Carefully place the topaz glass between the log set assembly.
E.
Repeat steps on the opposite side.
F.
note:
Do NOT cover triangular covers on the back side of the appliance. Blocking the triangular covers with media will
alter the flame appearance.
Fig. 1
4.3.2 acrylic crystal media installation
Install the acrylic crystal media after framing the appliance and before installing the front glass.
Remove the fasteners from the log set assembly. Keep the
A.
fasteners with the log set assembly for future use.
Remove log set assembly.
B.
Install media tray, ensuring NOT to re-install the fasteners as they
C.
can cause the media tray to bow when heated.
Carefully place acrylic crystals into the media tray, creating an
D.
even layer from side to side.
note:
Ensure to vacuum up any topaz glass or acrylic crystals outside the
media tray area before operation.
Do NOT cover triangular covers on the back side of the appliance.
Blocking the triangular covers with media will alter the flame appearance.
20
W415-1767 / F / 07.20.18
FIG. 3
All manuals and user guides at all-guides.com
Fig. 2
FIG. 3
Fig. 3
FIG. 3