E N
T U R N O F F M AC H I N E
1 low pressure coupling
2 safety valve
3 high pressure coupling
Put the electrical contact to position 'ON' (fuel engine
not started)! Move the control stick downwards and
simultaneously turn the key switch to position "START".
The antifreeze filling function indicator is now active and appears on the display
for 1.5 minutes (see "Display / failures" on page 26 )! Start the fuel engine
at idle speed! Spray till the antifreeze water flows out of the spray gun (this
indicates that the cleaner is filled with antifreeze) or wait till the antifreeze filling
function time is ended.
Remember:
loosen also the spray gun once, this to fill the bypass line
with antifreeze. 5 seconds after extinguishing of the lamp, the cleaner will
stop on "run dry water" (see section 11 - 4.2). The cleaner is now filled with
antifreeze, turn off the key contact and store the cleaner in a storage area.
Remark:
pay attention to the water supply hose & supply water filter, these
are not filled with antifreeze agent! You can uncouple the supply hose/
water filter and put away the hose/filter frost free. You also can drain the
water from the hose (eg.: by blowing with compressed air) or through the
water filter (by loosening the basket and draining the water from the hose).
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Antifreeze is an additive which may absolutely not been drained/
discharged without permission. You have to collect the outlet
antifreeze water in a reservoir. This is also the case when
you use the cleaner once more, the antifreeze water which
has been left in the cleaner will then flow through. Please do
always take into account the matching security measures.
Tip: You can use the collected water with antifreeze several times!
At starting the cleaner again:
• Fill the tank with water and start the cleaner.
• Capture the antifreeze till water flows out of the spray gun (see below).
2 O P T I O N : F I L L I N G K I T A N T I F R E E Z E ( S E E P H OTO B E LOW - 1 . 2 3 0.1 0 0 / 1 0 1 / 1 0 2 )
First loosen the basket from the water filter. Connect the filling set antifreeze to
the low pressure hose and to the high pressure hose (closed circuit).
Put the cleaner on idle speed and operate the spray gun. Keep the spray gun
pressed till the water flows out of the low pressure hose and there is filled with
antifreeze till the water filter. Turn the basket back on the filter and then push
again on the spray gun. Hold the spray gun until also the water filter (note the
color of antifreeze in the water filter) is filled with antifreeze (+- 20 litres).
Turn off the cleaner and disconnect the antifreeze filling set of the hoses.
The low pressure side is now also filled with antifreeze.
1
DiBO 34
2
3