Rel Ay O U T P U T S - ETATRON D.S. eTwin Notice D'installation, Emploi Et Entretien

Rel ay o u t p u t s

You may set three relay outputs
independently, associated respectively to:
PUMP_1 (pH), or Chlorine
•
PUMP_2 (Rx), or else pH, depending on
•
the model
TIMER
•
TEMPERATURE
•
Refer to fig. 9 for the connection of the
relays. By default, RELAY 1 is associated to
Pump_1, RELAY 2 to Pump_2 and RELAY 3 to
the TIMER. The timer of the relay function is
independent from the timer function
described in the following paragraph. There
are however four daily cycles, or else 4
cycles for each day of the week.
It is possible to decide whether to enable
the relay even in the absence of flow (default
DISABLED)
ENGLISH
55